6
Assembly
1. Li up the treadmill and using the ship bolts, x it onto the connecon board.
2. To install the handrail tubes rstly connect the holding wire and then plug in the armrest pipeline into the pillar
and bolt down.
3. Plug the two heartbeat lines according to right and le and then plug in the connecng lines.
4. Whilst aligning the indents to the tube also ensure both holes are aligned and fasten with M6 bolts.
Usage Instrucon
Warning: Please be sure to read the following before operang.
Do not stand on the running belt when starng the treadmill.
Please adjust the speed gradually to avoid sudden change of speed.
Please ensure the safety switch is kept on your body at all mes whilst using the treadmill.
Please ensure the key pad is dry at all mes to avoid the leakage of electricity.
Aer installaon and debugging the treadmill is ready for use.
1. Place the plug in the power socket.
2. Be sure the safety switch is placed in the safety socket, press the start buon to start the treadmill running.
Getting Started
1. 2.
3. 4.
To Next Page
Loading...
