• Settings of the device can be updated with the downlink message
• Device requests new settings approximately every 24 hours
• You must be very careful when you update the settings
• settings affect both the subscription and the battery life of the device!
• Downlink message is optional
• If any downlink message is not received, device continues with the
current settings
• Detection interval and how often messages are sent when the space is
available or occupied can be adjusted with the settings
• Default settings when device has not been configured with downlink:
• Default activity reporting period is 22minutes
• When the space is occupied, a message is sent after every activity
period with updated counter values
• When the space becomes available the status will be sent after
Inactivity Detection Period. The default value is 15minutes.
• After inactivity message has been sent, the device goes to Inactivity
mode: when activity is detected, status message will be sent
immediately with counters increased and activity mode starts
• Default inactivity reporting period is about eight hours
• After inactivity period has expired without activity detected, the status
message is sent without counters increased and new inactivity period
starts
• If the power control feature is set on, the device will automatically adjust the
transmit power to optimum level to save battery and create less unnecessary
interference to radio network
• By default power control is OFF
To Next Page
Loading...