Need help?Do you have a question about the Conqueror FBC200 and is the answer not in the manual?
Procedure for operating the door manually during power failure or malfunction.
Steps to add new remote transmitters to the garage door operator.
Process to remove previously programmed remote transmitters from the system.
How to set the upper and lower travel limits for the garage door.
Procedure to adjust the force sensitivity for obstruction detection.
Instructions on enabling or disabling the infrared photocell safety feature.
How to activate and use the door lock mode for security.
General| Horsepower | 1/2 HP |
|---|---|
| Frequency | 60 Hz |
| Installation Type | Ceiling Mount |
| Voltage | 120V |
| Power Supply | AC |
| Control Type | Remote Control |
To Next Page