Need help?Do you have a question about the Consilium Salwico ST400 H2S and is the answer not in the manual?
General| Technology | Electrochemical |
|---|---|
| Response Time (T90) | < 30 seconds |
| Detection Range | 0-100 ppm |
| Resolution | 0.1 ppm |
| Output | 4-20 mA |
| Gas Type | Hydrogen Sulphide (H2S) |
| Operating Humidity | 15% to 90% RH (non-condensing) |
| Certifications | ATEX, IECEx |
Introduction to the Salwico ST400 H2S detectors and sensor technology.
Details on calibration gas bottles and related article numbers for H2S detectors.
Steps required before calibration, including menu navigation and disabling the detector.
Procedure for zero calibration, adjusting the 'ZERO' potentiometer to 4.0 mA output.
Verification of detector type and span calibration for H2S sensors using specific mA signals.
Steps to re-enable a disabled detector through the system's disablement list.
To Next Page
