GENERAL USE
1. Power up meter.
When power is switched on, the light in the meter will bright. The meter will show AC input voltage. If
the pointer goes out of green area, the D-linear15 will shut down for over voltage protection. If the
pointer goes to red area is the low voltage warning.
2. AC power switch.
3. AC power plug.
4. AC outputs for AMP: 4x sockets for power amplifier and integrated amplifier.
5. AC outputs for Analog Source: 2x sockets for pre-amplifier and phono-stage.
6. AC outputs for Signal Source: 4x sockets for CD player, digital stream player and DAC.
To Next Page
Loading...