en Wipe protection
36
kWipe protection
Wipe pr ot ec t i on
If you wipe over the control panel while the cooktop is
switched on, settings may be altered.
To prevent this from happening, your cooktop has a
wipe protection function. Touch the symbol @/R. An
audible signal sounds. The indicator light above the
symbol
@/R lights up. The control panel is locked for
30 seconds. You can now wipe over the control panel
without altering any settings.
Note: The main switch is excluded from the wipe
protection function. You can switch off the cooktop at
any time.
[Energy consumption
indicator
En e r g y consumpt i on indicator
You can use this function to display the total energy
consumption between switching the hob on and off.
Once switched off, the energy consumption is displayed
in kilowatt hours (e.g. 1.08 kWh) for 10 seconds
The accuracy on the display depends on the voltage
quality of the power supply, among other factors.
The display has not been activated. You can find out
how to activate the display in the Basic settings
section.~ Page 36
QBasic settings
Ba s i c set t i ngs
Your appliance has various basic settings. You can
adjust these settings to meet your own needs.
Display Function
™‚
Automatic child safety lock
‹
Switched off.*
‚
Switched on.
ƒ
Manual and automatic child safety lock switched off.
™ƒ
Beep
‹
Confirmation signal and operation error signal are
switched off (primary switch signal always remains).
‚
Only the operation error signal is switched on.
ƒ
Only the confirmation signal is switched on.
„
Confirmation signal and operation error signal switched
on.*
™„
Energy consumption display (Ask your electric com-
pany what the mains voltage is)
‹
Consumption display switched off.*
‚
Consumption display with mains voltage at 230 V.
ƒ
Consumption display with mains voltage at 400 V.
„
Consumption display with mains voltage at 220 V.
…
Consumption display with mains voltage at 240 V.
™†
Automatic timer
‹‹
Switched off.*
‹‚-ŠŠ
Cooking time after which the hotplates switch off.
™‡
Duration of the timer end signal
‚
10 seconds.*
ƒ
30 seconds
„
1 minute.
™ˆ
Activation of the heating elements
‹
Switched off.
‚
Switched on.
ƒ
Last setting before the hotplate was switched off.*
™Š
Selected time for the hotplate
‹
Unlimited: the most recently selected hotplate can always
be adjusted without having to select it again.*
‚
Once you select a hotplate, you have 10 seconds to adjust
it, after which you will have to select it again in order to be
able to adjust it.
™‹
Reset the basic settings
‹
Switched off.*
‚
Switched on.
*Basic setting
To Next Page
Loading...
