CONSTRUCTA CD75132 - Troubleshooting; Malfunctions

en Troubleshooting
24
2.
If the appliance has a spacer rail, remove this.
3.
Use a screwdriver to push the two tabs on the inter-
mediate floor inwards.
4.
Use the enclosed sealing strips to mask the odour
filter.
5.
Insert the odour filter at the rear and fold it up ⁠.
6.
Lock the odour filter in the centre using the wing nut
⁠.
7.
If the appliance has a spacer rail, insert this.
8.
Install the grease filters.
→"Installing the grease filters", Page23
8.10 Replacing the odour filter
Requirement:The grease filters have been removed.
→"Removing the grease filter", Page22
1.
If the appliance has a spacer rail, remove this.
2.
Unlock the odour filter in the centre using the wing
nut and remove it.
3.
Replace the odour filter and lock it in place using
the wing nut.
4.
If the appliance has a spacer rail, insert this.
5.
Install the grease filters.
→"Installing the grease filters", Page23
9 Troubleshooting
You can rectify minor faults on your appliance yourself. Read the troubleshooting information before contacting after-
sales service. This will avoid unnecessary costs.
WARNING‒Risk of injury!
Improper repairs are dangerous.
▶
Repairs to the appliance should only be carried out
by trained specialist staff.
▶
If the appliance is defective, call Customer Service.
WARNING‒Risk of electric shock!
Incorrect repairs are dangerous.
▶
Repairs to the appliance should only be carried out
by trained specialist staff.
▶
Only use genuine spare parts when repairing the
appliance.
▶
If the power cord of this appliance is damaged, it
must be replaced by the manufacturer, the manufac-
turer's Customer Service or a similarly qualified per-
son in order to prevent any risk.