6 Take care when moving the machine on a sloping surface, substantial rolling forces can
be produced.
7 The hooks of a crane can only be placed in the lifting points.
8 The machine should always be stored in a warm, dry place when not in use.
9 The floor grinder may only be operated with the dust guard (Appendix diagram No.1).
10 Only CONTEC
®
original tools and spare parts are to be used.
11 The grinder should only be operated with all safety guards in position.
12 When changing tools, during transportation, cleaning, repair or maintenance the grinder
must be disconnected from the mains.
13 The operator must never leave the machine unattended during operation.
14 Before leaving the machine all rotary parts must be brought to a standstill. Electric
models must be disconnected from the power supply. Ensure the machine cannot roll or
move by itself.
15 Never wear loose or badly fitting clothing. Flapping sleeves may be pulled into the
machine causing serious injury.
16 The DELTA should be switched off immediately if unusual noises or vibrations are
detected during the operating of the machinery. A thorough check must be carried out in
order to detect the cause.
17 Check the power cables regularly as damage may have occurred while operating the
machine. Always disconnect the cables before examination and treat all electrical parts with
extreme care.
18 After any maintenance and adjustment all safety guards must be refitted.
19 Ear protectors must be worn.
20 Eye protectors must be worn.
21 Safety shoes with steel caps must be worn.
22 When operating the grinder produces large volumes of dust the grinder should be
connected to a suitable dust collector.
23 Depending on the floor (floor coating) grinding can produce gases. The operator must
be held responsible if the gases generated are hazardous and whether protection is
necessary. Grinding floors containing asbestos is especially dangerous and can cause
health problems. Special masks must be worn which keep the breathing air clean. A dust
collector must be used and should be equipped with filters suitable for asbestos dust.
24 The floor must be brushed before grinding to prevent loose material collecting in the
tools and then being thrown out with force. Anchor screws and bolts in the floor can also
be seen better if the area is clean. If the grinding head strikes an anchor screw or bolt then
serious damage can be caused to the machine and grinding head.
Operating the DELTA has to be carried out according to the safety rules in Chapter 4.
Bring the grinder to the floor.
Connect a hose to the DELTA and to the dust collector. It is important, that the entire length
of the hose has no holes and is completely air tight. Small holes or a bad connection can
extremely decrease the performance
Check all the electric cables.
To Next Page
Loading...
Need help?
General