EasyManua.ls Logo

Continental Electric CE73096 - Outdoor Unit Installation; Outdoor Unit Mounting Methods (I, II, III)

Default Icon
66 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Warning
Each time you bring the outdoor unit insidealways turn the air eondilioneroff at the
power supply If you do not and move the insideunit the debumidif'_l water in the
container inside the unit couldactivate the water pump and discard water from the
tube on the outdoor unit,
The Outdoor Unit
Model: CE77126 Only
METHOD I :
The outdoor unit may be placed on outdoorpatio or flower planer directly, so it
does not require the special mounting brackets.
PTease make sure that the drainage
pipe is not pressed by the outdoor
unit! 5_,,
120¢i
(Open space) 1
METHOD II :
The outdoor unit may be mounted on the wall by utilizing the enclosed accessories
(mounting brackets, wall plug and the screws).
When using this method you can
extend the drainage tube and direct
it to where you wish tl'_. water to
discharge. You can lift t_-.._ _,utside
unit off the brackets at .mv time.
If you intend a permanent fitting, for
the outside unit we recommend to
make a cover for it to prevent water
getting inside in heavy rains.
METHOD III :
For short-term application, please use the enclosed belts to hang the outdoor unit
outside the window.
With this method we recommend
in heavy rain storms and wind to
turn the unit off and lift inside if you
do not have the unit suitably covered•
Always use the belts on the mounting
brackets, do not tie belts on handle.