1
2 3
Make sure your RollerMouse Red is unplugged. Remove the short
wrist rest if still attached, by using the enclosed key.
Insert key into slot next to arrow on bottom of RollerMouse Red.
Turn in direction of arrow to release the short wrist rest
at each end. Separate the units.
To attach Red Plus Palm Support, line up both units as shown.
The tongue that runs along Red Plus Palm Support ts
inside the groove that runs along front edge of RollerMouse Red,
between the two red end caps.
Insert the tongue into the groove.
Side view of Red Plus Palm Support and the RollerMouse Red.
To Previous Page
Loading...
