6
+
RECHARGE
To recharge your camera, connect the camera to a PC/Mac
using the supplied USB Cable.
+ Red Battery Status LED indicates charging.
+ Charge is 80% complete in one hour.
+ Charge is fully complete when Battery Status LED turns
green (about 4 hours).
+ RESETTING YOUR CAMERA
If your camera is locked up or it will not stop recording,
you can reset the camera.
- Slide the Record Switch back to the Stop position.
- Press and release the Reset Button (See ‘G’ on page 1).
- The camera will shut off all LEDs and power off.
- Your camera will be ready to operate again.
To Next Page
Loading...
