17
Contour+ User Manual
+
BLUETOOTH
The Contour+ has Bluetooth 2.1 + EDR onboard and a Connect View
card pre-installed. Using a mobile device and the Contour Camera
mobile app, you can configure your camera settings in real-time and
preview what your camera sees.
+ Check the compatibility of your mobile device at www.contour.com/mobile.
+ Download and install the Contour Camera mobile app onto your mobile device.
+ Press Bluetooth button (see C on page 1) and hold it down for 5 seconds,
this turns Bluetooth on and initiates a pairing request. The front LED
will begin flashing blue. (Note: if you slide the record switch forward the
camera will go out of Bluetooth mode).
+ On your Mobile device, enable Bluetooth. Wait while your mobile device
locates the Contour+ camera. Once you see ‘Contour+’, select
it to accept the pairing request. You will know the pairing is complete
when the front LED on the camera goes solid blue.
+ Open the Contour App to configure your camera settings in real-time
and preview what your camera sees.
+ If your Bluetooth connection is lost the app will let you know; if this
happens, you’ll need to turn your Bluetooth back on by pressing
the Bluetooth button once. A single beep will sound and the camera
will connect with the pre-existing pairing.
+ To turn Bluetooth off, press the Bluetooth button on your camera.
To Next Page
Loading...
