MiniWarden/PoolWarden + (PLUS) Operation Manual • www.poolwardentraining.com • 5
8 WARNING – Disconnect all power to PoolWarden prior to any service
including the main AC power and any other AC sources that may be
connected to the AUX relays. Never apply power when PoolWarden
service door is unlocked or in the open position. Only qualified and
licensed technicians should perform any service or repair.
9 WARNING – Do not install load bearing leads and/or sensor cables
longer than 3 meters.
10 WARNING – Always mount PoolWarden in safe and dry area. Never
mount PoolWarden above any other electrical equipment.
11 WARNING – Install PoolWarden in a location that is not accessible to
the public.
12 WARNING – Pool and Spa Chemical Safety
12.1 Never mix sodium hypochlorite and muratic acid!
12.2 When mixing acid and water, always add acid to the water, never
add water to the acid.
13 CAUTION – TEST THE GROUND FAULT CIRCUIT INTERRUPTER
BEFORE EACH USE OF THE POOL/SPA
14 CAUTION – CONNECT ONLY TO A CIRCUIT PROTECTED BY A
CLASS A GROUND FAULT CIRCUIT INTERRUPTER
15 WARNING – When using the TrueDPD free chlorine sensor, if it
measures 0.0 (no chlorine) that will not cause the sanitizer relay to
turn on to prevent over-chlorination. This may happen if the DPD
reagent bottle is empty.
16 Do not dispose in trash. Please visit www.controlomatic.com
for recycling information.
1 ATTENTION: TOUJOURS VÉRIFIER L’EFFICACITÉ DU DISJONCTEUR
DIFFÉRENTIEL AVANT D’UTILISER LE BAIN
2 ATTENTION: LIRE LA NOTICE TECHNIQUE
3 AVERTISSEMENT: DÉCONNECTER DU CIRCUIT D’ALIMENTATION
ÉLECTRIQUE AVANT L’ENTRETIEN
4 ATTENTION: CONNECTER UNIQUEMENT À UN CIRCUIT PROTÉGÉ
PAR UN DISJONCTEUR DIFFÉRENTIEL DE CLASSE A
IMPORTANT WARNING AND SAFETY INSTRUCTIONS
To Next Page
Loading...
