Controls MVP-M102 - Page 12

CONTROLS, INCORPORATED
C O N T R O L S Y S T E M S & S O L U T I O N S
- 11 -
Configuration Menus
(1)
Input Configuration
Analog 1 Function
Digital 1 Function
(2)
Module Configuration
Units (English/Metric)
Hour Meter Source (Default = Engine ECU)
Hour Meter Setting
Display Battery Source (Default = J1939)
Battery Volt Trim (Default = 5 100mV)
Low Power Mode (Default = On)
Power Save Delay (Default = 2:00)
Multi Plex Communication (Default = Mode A)
Multi Plex Timeout (Default = 500 msec)
Pre Alarms Displayed (Default = 4)
(3)
CAN bus Configuration
Source Address (Default = 44) Others available
Engine Address (Default = 0) Others available
Oil/Fuel Transmit
Faults Transmit