Owner’s / Installaon Manual
Performance Series
M7204RF
Mounng the Monitor
1) Select a locaon allowing 2” space between monitor and walls, cabinets, or other objects to allow adequate air circulaon
around it. Avoid enclosed spaces, areas with excessive vibraon or subject it to severe impacts.
2) Never use this device in environments with excessive moisture, dust or smoke. Do not place cables where they may be
pinched or stepped on. Monitor is not designed to be waterproof.
3) The device may be powered by a 12 or 24 volt automove baery or vehicle electrical system.
4) Make sure all cables are connected properly, observe polarity. Improper cable connecons may damage the monitor. Remove
the power cable connecons when you do not intend to use the unit.
Installaon Notes: Trigger wire funcon
• Cycle between either CAM 1, CAM 2, CAM 3, CAM 4. When the trigger wire is energized, the monitor automacally switches
to view THAT Camera. When voltage is removed from the trigger wire, monitor returns to previous view. The Monitor only
has one RF receiver, so it can only view one wireless camera image at a me.
• If the monitor is o, when the trigger wire is energized, the monitor will turn on to show THAT Camera. This safety feature is
parcularly useful for night driving, as the monitor light can be distracng to the operator.
• To get the camera into “Pairing Mode” hold the Pairing buon 6 seconds. Hold the “Pair” buon on the M7204RF 3 seconds.
The monitor will start counng down from 50 sec, and when it nds and pairs with the camera, you will see “SAVE DATA” on
the screen, then the picture from the camera.
M7204RF Harness:
• Red and Black—Power (12-24VDC) and Ground
• Green—Trigger Wire for Channel 1
• White—Trigger Wire for Channel 2
• Yellow—Trigger Wire for Channel 3
• Blue—Trigger Wire for Channel 4
Convoy Technologies Inc.
6409 Highview Drive, Fort Wayne, IN, 46818 USA
To Next Page
Loading...
Need help?
General