1. Open the cover of the water tank and pour the appropriate amount of water into the
water tank.
Note: The amount of brewed coffee will be less than the amount of water, because the
ground coffee absorbs some of the water.
2. Do not pour hot water, milk, coffee powder or tea into the tank.
3. When adding water to the tank, it can not exceed the position of the maximum scale line
of the water gauge.
4. The water added to the tank should be consistent with the mode of selected cups.
5. Pull the strainer cup back out, making sure the strainer is inside the strainer cup.
6. When the filter cup is stuck on the slide rail, push it forward and hear the sound then
install it in right place.
7. Add beans: Pour an appropriate amount of coffee beans into the bean box (no more
than 150g) and cover the bean box. In order to avoid wet coffee beans and ensure the
aroma of coffee, it is recommended not to put too many coffee beans into the bean box.
Add powder: Pull the filter cup back, use the attached measuring spoon to add the
required coffee powder, each measuring spoon weighs about 6g, reinstall the filter cup.
8. Set the current time: The machine is plugged in. The control panel displays "0:00 ", the 0
on the left represents the hour, the 00 on the right represents the minute, press the "Time"
key, at this Time the T above the "Time" key flashes and the hour light flashes, press the "<"
key, or ">" key, and then press the "time" key, the hour light is always on, the minute light
flashes, then press the "<" key, or ">" key, and the minute is increased or decreased. After
you press Start/Stop, the system enters the basic mode.
B. Reset the time: Set the time as follows: A. Set the current time.
Note: When the power is cut off due to unplugging or power failure, the clock will be reset.
When the clock is reset, set the clock again. (The machine can work normally without setting
time).
9. Cup selection function: In standby mode or basic mode, click "Cups" to increase the
number of Cups. If you click "Cups" repeatedly, cups will continue to sequencing from
largest to smallest.
10. Bean/Powder selection function: In standby or basic mode, click the "bean/powder" key:
to choose whether to use the bean grinding function or add the ground coffee.
11. Concentration selection function: In the standby state or basic mode, click the "Strength"
key to select the coffee intensity. The single bean above the "Strength" key means light
coffee, two beans mean medium coffee, and three beans mean strong coffee.
12. The thickness of the coffee powder can be adjusted by turning the knob inside the bean
box.
Note: The mark indicates that the coffee powder has changed from fine to coarse, and
medium is recommended.
13. Brewing coffee: press the "Cups" key, select the required cup quantity, press the
"Strength" key, select the coffee concentration you like, and then click the "start/stop"
button in the middle, the machine starts to brew coffee, until the buzzer sounds to indicate
the completion of brewing, and then the machine automatically enters the heat preservation
state.
OPERATION GUIDE
To Next Page
Loading...