47
Appendix...
GB IE
Installation
Hob installation
> Cut a hole in the worktop of the size shown in the diagram. The worktop
should be at least 30 mm thick and made of a heat-resistant material.
Seal cut edge of the worktop with silicone or PVA.
> Attach the brackets and place the hob into the cut out and push down
rmly.
Electrical connection
Caution
The ceramic hob must be installed by a
suitably qualied person. Never try to install
the appliance yourself. The ceramic hob must
not be installed above refrigerators, freezers,
dishwashers or tumble dryers. The wall and
the area above the hob should be able to
withstand heat.
Caution
• The cord should not be extended or folded
into coil during operation.
• Adapters, multi-socket strips and
extension leads must not be used.
• Overloading could result in a risk of re.
Caution
Before connecting to the power supply, check:
• The voltage meets requirements.
• The appliance uses an individual socket and
does not share one with another electric
appliance. A dedicated power protection
switch must be incorporated in the xed
wiring in accordance with the wiring rules.
To Next Page
Loading...
Need help?
General
