Coolair CPL450 - Using The Cooler; Air Too Cold; Air Not Cold Enough

5
CPL EvaporativeCooler
®
TIMED AUTOMATICSTART
TIMED AUTOMATICSTOP
Youcansettheaircoolersothatitwill
turnonafterasetnumberofhours.
1.Tosetthedelayedstarttime,press
withthecoolerturnedOFF.
“Startingin” willbedisplayedasshown
withthelastmodeofoperation(Manual
or Automatic).
2.Ifyouwanttheaircoolertoturnonin
Automaticmodewiththeprevious
settings,thenpress until “Auto”
isdisplayed. Alternatively,ifyouwant
theaircoolertoturnoninManual
mode,press until “Man” is
displayedandthenpress and
thenortosettherequiredfan
speed.
3.Tosetthetimeuntilthestart,press
.
4.Thenpressortoadjustthe
time. Thecoolercanstartupto24
hoursinadvance.
5.Press againtoinitiatethe
timedautomaticstart. Thetimedstart
willnotrepeat.
Youcanalsosettheaircoolersothatit
willturnoffafterasetnumberofhours.
1.Tosetadelayedstoptime,press
withthecoolerrunning.
”Stoppingin” willdisplay.
TIMER
AUTO
AUTO
COOL
TIMER
TIMER
TIMER
2.Pressortoadjustthe
numberofhoursbeforetheair
coolerwillstop. Themaximum
delaysettingis24hours.
3.Press againtobegin
thetimedstop.
TIMER
6SEELEY INTERNATIONAL – OWNER’SMANUAL
USINGTHECOOLER
Nowthatyouhavereadthese
instructions,pressthe
buttontoturnyouraircooleron.If
theaircoolerhasnotoperatedfor
awhile, “PreCoolCycle” willflash
onthedisplay. The “PreCoolCycle
willbeginandwilltakeonlyafew
minutestocomplete. Afterthis
time,thefanwillcomeon
automatically,andyoucanenjoy
thecomfortofcoolfreshair!
POWER
AIRTOOCOLD
Withthecoolerrunningin Automatic
mode,youmayfindthatyouaretoo
coldorthattheaircoolerisblowing
toomuchair.Presstolowerthe
automatictemperaturesettingand
reducetheamountofcooling.
Ifyouaretoocoldwiththecooler
runninginManualmode,thenpress
toreducethefanspeed. Youcan
alsocirculatefreshuncooledairby
pressing until “Vent” displays.COOL
AIRNOTCOLDENOUGH
Youmayfindthatwiththeaircooler
runningin Automaticmode,youare
notcoolenough.Simplypressto
increasethecoolingrate.
Ifyouarenotcoolenoughwiththe
aircoolerrunninginManualmode,
thenpresstoincreasethefan
speed.Ensurethatcooledairis
circulatingbypressing until
“Cool” displays.
COOL
Youcanexperimentwiththe
settingsonyourwallcontrol.
Thisisthebestwaytogetthe
mostfromyouraircooler.