44
44
4
The ON/OFF button turns the cooler on and
off.
There are two modes of operation to choose
from, Automatic mode or Manual mode. When
the cooler is turned on, it will start in the mode
of operation it was in when last turned off.
If your cooler has not been operated for a
while, then when you start it, “Pre Cool Cycle”
may sometimes flash on the display as shown.
This indicates that the water pump will oper-
ate to saturate the cooling pads for a few min-
utes before the fan is turned on. This is to
ensure that when the fan starts, only cool air
enters your home.
STARTING YOUR COOLER
THERMOSTTHERMOST
THERMOSTTHERMOST
THERMOST
AA
AA
A
T FUNCTIONST FUNCTIONS
T FUNCTIONST FUNCTIONS
T FUNCTIONS
ILL1085-A
ILL1203-A
To Next Page
