20
Figure 15.
STEP 15
This step is a repeat of step 12 but at the opposite end of the gazebo. Remove the
crank bolt from the (B1) beam using the Allen key (X). Position the louvre at the top
of the gazebo with the attached arm (L), lining up the louvre arm (L) with the crank
socket on the (B1) beam, just above the crank handle (second cradle position). Place
the louvre pin on the other end of the louvre in the second cradle position on top of
the B2 beam.
Assemble the rst slice to the le.
To Next Page
Loading...
