NOTE
IMPORTANT! If you are not using Wi-Fi and you have an EE showing on the display follow these steps:
1. Unplug the CoolBot Pro from the power supply
2. Disconnect the Jumper from the CoolBot – disconnect the Data Cable (if it was connected)
3. Plug your CoolBot Pro back in. You will see EE
4. Follow steps 1, 2, and 3 for rebooting the CoolBot Pro to get to the main program menu options
5. Scroll (with the arrows) to the CE option and select (checkmark) then choose (with the arrows): Y
6. Press Checkmark. Your CoolBot Pro should stop blinking and revert back to show the Room
Temperature (It is ready to use in the “No Wi-Fi Mode”)
From the app
DEVICES TAB - Hardware Setup Menu
Clicking on the Hardware Setup Expandable Menu gives you choices for resetting your CoolBot Pro,
downloading latest firmware for the CoolBot Pro controller, and reconfigure your Wi-Fi connection.
1. Factory Reset – Use this option to reset your CoolBot (ONLY) to Factory Settings while keeping your Wi-Fi
configuration. This is the same as “CS” from the CoolBot Controller program Menu.
2. Update Firmware – This option downloads the latest Firmware version to your CoolBot JUMPER. It is not
really a Reboot but an update for Firmware. The tab will become gray and the Status Icon will indicate
“updating” in yellow until done.
3. Reconfigure Wi-Fi – This option will walk you step by step through the entire Wi-Fi configuration process
(just like the first time you set up your CoolBot Pro to connect to your Wi-Fi Network). A Jumper reset (“CJ” or
“Fr”) will be necessary (see From the CoolBot Pro Controller section above) so the Jumper resets and the
CoolBot displays “E0” meaning that it is ready for a Wi-Fi set up again.
© 2018-12A Store It Cold, LLC
To Next Page
Loading...