CoolBot Pro - User Manual

CoolBot Factory Reset
Not Applicable to 2G Model (CoolBot with cables on top and side)
CoolBot Pro
From the CoolBot Pro Controller
1. On the CoolBot, press the left arrow button until the Program light is solidly lit. You will see the
firmware version on the display (7.8, 7.9, etc.).
2. Press the Checkmark button five times slowly, until you see “P1” on the display.
3. Press the Left Arrow a few times to get to the reset option you want:
○ P1: resets all settings (Same as “Fr”)
■ Full factory reset of CoolBot and Jumper IF the Jumper is connected.
■ Full factory reset of the CoolBot only, if the Jumper is disconnected.
○ ES: escapes from this menu and returns to normal operation
○ CJ: clears the Jumper’s (Wi-Fi radio) settings only. The Jumper HAS to be connected to the CoolBot
Pro.
○ CE: Wi-Fi Mode disabled: Y=Not using Wi-Fi, N=Using Wi-Fi (See NOTE below)
○ CS: clears the CoolBot’s settings to defaults but keeps the Wi-Fi settings the same.
○ Fr: resets all settings (Same as “P1”)
■ Full factory reset of CoolBot and Jumper IF the Jumper is connected.
■ Full factory reset of the CoolBot (ONLY), if Jumper is disconnected.
4. Press Checkmark to select that reset option.
5. You will see a blinking “n” for “no”. Press one of the arrow keys to change it to “y” for “yes.”
6. Press Checkmark. The CoolBot will reset the selected settings.
7. If you chose P1, CJ, or Fr with the Jumper connected to the CoolBot Pro, the CoolBot will switch to its
Wi-Fi Configuration mode. You should see the code “E0” on the display. This means it’s ready to
reconfigure Wi-Fi.
8. The CoolBot set temp has been reset to factory setting of 42F, change it to your desired room temp.
(continue on page 2)
 © 2018-12A Store It Cold, LLC

Summary

CoolBot Factory Reset

Factory Reset via Controller

Instructions for performing a factory reset using the CoolBot Pro's on-device interface and menu options.

Factory Reset via Mobile App

Guide to reset the CoolBot Pro using the mobile app's hardware setup menu, preserving Wi-Fi settings.

Firmware Update via Mobile App

Procedure to download and install the latest firmware for the CoolBot Jumper using the mobile application.

Reconfigure Wi-Fi via Mobile App

Steps to reconfigure the CoolBot Pro's Wi-Fi connection via the mobile application.

Factory Reset for 6.5 or 6.4 Versions

Specific instructions for performing a factory reset on CoolBot versions 6.5 and 6.4.

Factory Reset for 6.3 Version

Specific instructions for performing a factory reset on CoolBot version 6.3.

Factory Reset for 6.1 Version

Specific instructions for performing a factory reset on CoolBot version 6.1.

CoolBot Pro Specifications

General

Brand	CoolBot
Model	Pro
Category	Controller
Language	English