01. Controller Description 02. LED Modes
03. Addressable RGB/RGB Mode 04. Addressable RGB/RGB Mode
5. Addressable RGB/RGB Mode
06. Color Adjustment Mode
Front Back Left Right
Top Bottom
Press:
1. Spectrum Cycle
2. Uni-LED Monotone
Step Cycle
3. Dual-LED Monotone
Step Cycle
4. Breathe Cycle
5. Monotone LED
Build-up Cycle
6. Chromatic LED
Step Cycle
7. Turn Off
8. Testing Mode
Default:
When plugged in right side
4 LED will light up. For the
purpose of demonstration
they will be shaded to
indicate that it is on
Press Once:
To Switch to standard RGB
Mode
Press Again:
To switch back to
Addressable RGB mode
Press:
To switch colors in LED
mode
NOTE:
In LED mode 1 and 6 this
is not applicable as it is a
multi-color function.
IMPORTANT: the 7 LEDs indicated in the next 3
steps are built internal, indicated in the
illustration for explanation purposes. Will not be
visible when off
Note:
After switching to RGB
Mode, right side 1 LED Will
light up
Note:
Bottom 2 LED always on
when plugged in
USER MANUAL
To Next Page
Need help?
General