Air humidity controller: The air humidity level can be set in a range from 10 % relative air humidity to 80 % relative air
humidity.
For dryer air, rotate the controller clockwise to a low percentage value.
For moister air, rotate the controller counterclockwise to a higher percentage value.
If the controller is set to , the air dehumidifier will work towards maximum dehumidification until the collector tank is full.
To deactivate the appliance, set the selector switch to .
Indicator lamp: Once the appliance has been activated, this lamp illuminates permanently (the appliance is ready for
operation). When the appliance is deactivated, the lamp extinguishes.
Indicator lamp: This display illuminates when ice forms on the evaporation coils, the compressor switches off and the
blower continues to runs until the ice has disappeared.
Indicator lamp: This illuminates when the water container is full. The appliance stops operating automatically. The water
container must be emptied.
NOTE
The appliance takes up to 5 minutes to respond to the changed settings.1.
If you have deactivated the air dehumidifier, wait 3 – 5 minutes before activating again.2.
To Next Page
Loading...
