Zenkuru Inatable spa
SPECIFICATIONS
• Seats up to 4 adults
• Water capacity: 800 L
• External diameter: 180 cm
• Internal diameter: 140 cm
• Height: 65 cm
• Number of air jets: 130 pcs, each 3 mm in diameter
• Wattage: 220-240V, 50Hz
• Heating device: 1200 W
• Air blower (jets): 600 W
• Cable length: 3.3 meters
• Filter: 12V AC, 50Hz, 30W, 1880 L
• Material, pool: PVC
• Material, top cover: laminated PVC
• Net weight: approx. 22 kg
• IP-code: IPX5
• Package contains: 1 x inatable spa, 1 x
top cover with cover xation, 1 x Ination
hose, 1 x lter cartridge, 1 x ground
sheet,1 x repair kit, Manual
USE
• Intended for outdoor use only
• Never leave children without closely supervision in the
water or close to the spa.
• If you are pregnant or have a history of heart disease,
high or low blood pressure or circulatory system prob-
lems: consult a medical doctor before using the spa.
• Leave the water immediately if you feel pain, nausea,
drowsiness or if you feel uncomfortable.
• Never use alcohol, drugs, or medication prior to using
the spa as this increases the risk of hyperthermia.
• The water in a spa should never exceed 40°C. Water
temperature between 38°C and 40°C are ideal for an
adult. Lower water temperatures are recommended
for children and when spa use exceeds 10 minutes.
• To reduce the risk of injury, never pour water warmer
than 40°C into the spa directly.
INSTALLATION AND OPERATION
• Keep a recommended distance of 3.5 meters
between the spa and electrical outlets.
• Never connect the spa to a powerline that doesn’t
have a residual-current device (RCD) installed.
• Electric installations should fulll the requirements of
local standards. Earthed appliances must be perma-
nently connected to xed wiring.
• Never use the spa if the supply core is damaged to
avoid hazards.
• Parts containing live parts, except parts supplied with
safety extra-low voltage not exceeding 12 V, must be
inaccessible to a person in the bath.
• To reduce the risk of electric shock, do not use exten-
sion cord to connect unit to electric supply.
Before operating this product, please read these instructions completely and save this manual for future use.
• All parts incorporating electrical components, except
for remote control devices, must be located so that
they cannot fall into the bath.
• To avoid the risk of electric shock, never operate any
electrical appliance when in the spa or when your
body is wet. Never place any electric appliance, such
as a lamp, telephone, radio, or television, within 1.5m
of a spa.
• Install the spa at least 1.5m from all metal surfaces.
• To avoid electric shock, do not use the spa when it is
raining.
• To avoid damage to the pump, the spa must never be
operated unless the spa is lled with water.
• When turning on the jet function, make sure the cover
of spa is opened rst.
• Do not switch on if there is any possibility that the
water in the spa is frozen.
• The spa should not be setup or left out in tempera-
tures lower than 4°C.
• Never dry-run the power pack as such type of opera-
tion will damage it.
INSTALLATION INSTRUCTION
Ensure to check all parts are present:
a. Spa pool
b. Top cover with foil and zipper
c. Ination hose
d. Filter cartridge and fabric cover
e. Drain plug
f. Repair kit
g. Ground sheet
SITE REQUIREMENTS
• Place only on surface that can withstand the oor loading requirement of your spa.
• Because of the combined weight of the spa, water, and users, it is extremely important
that the base where the spa is installed is smooth, at, level and capable of uniformly
supporting this weight for the entire time the spa is installed.
• During lling, emptying or when in use, water may spill out of the spa. The spa should be
installed near a ground drain.
• Always have the spa locked with its cover after each use.
EN
To Next Page
Loading...