Coopers 9082 - Engine Start Procedure; Throttle and Choke Operation

14
3.While holding the throttle trigger and pressing down on the
throttle interlock, push in the side throttle lock button and
release the throttle trigger to hold it at the starting position (F7).
(4) Throttle lever
(5) Throttle trigger
(6) Throttle interlock
4. Pull out the choke knob (F8)
(7) Choke knob.
5. While holding the chainsaw unit securely on the ground, pull
the starter rope vigorously (F9). Pull the starter rope upwards,
not to the side. Pulling to the side may cause the rope to fray. It
may take 3 or 4 pulls to start the engine. If the engine does not
start after 3-4 attempts, open the choke further and try again.
Warning
Do not start the engine while the chainsaw hangs in one hand.
The saw chain may touch your body. This is very dangerous.
6.When the engine has started gradually push the choke in.
7. Allow the engine to warm up with the throttle lever pulled
slightly.
8. Release the chain brake by pulling it towards you.
Warning
Keep clear of the saw chain upon starting of engine.
Operation
(F7)
(F8)
(F9)
!
!
(6)