Need help?Do you have a question about the Copland CSA29 and is the answer not in the manual?
Welcomes the user and advises reading the owner's manual before operation.
Provides essential safety warnings regarding voltage, moisture, and qualified servicing.
Instructions for unpacking and placing the amplifier, emphasizing ventilation.
Guidance on using shielded cables for signal sources and speaker wire selection.
Details on connecting the amplifier to the wall outlet and voltage requirements.
Selects the appropriate input signal source for the amplifier.
Enables listening to tapes and monitoring recordings; bypasses source selector when active.
Switches the amplifier cyclically between operation and standby mode.
Adjusts the amplifier's volume to the desired listening level.
Provides earth connection for any device requiring grounding.
Input for turntables, supporting magnetic or high output MC cartridges.
Record output jack for recording signals reproduced by the amplifier.
Input for connecting playback outputs from tape recorders or cassette decks.
Accepts the audio signal from a tuner.
Input for connecting a CD player.
General purpose inputs for any high output devices.
DC jacks for remote on/off operation of connected CD players.
Terminals for connecting left and right loudspeakers to the amplifier.
Connection point for the AC Power Cord.
Guidance on amplifier longevity, valve replacement, and contacting service agents.
Information on the warranty period and how to claim service.
Technical details including vacuum tubes, output power, frequency response, and dimensions.
Power Output| output power | 2 x 85W channel at 8 Ohms |
|---|---|
| power bandwidth | 10 Hz – 20 KHz – 0, 5dB |
| total harmonic distortion | Less than 0, 05% at all levels |
Frequency and Sensitivity| frequency response | 10 Hz – 120 KHz – 3 dB |
|---|---|
| input sensitivity phono | 2, 7mV (optional RIAA board) |
| input sensitivity CD line | 250 mV |
Impedance and Noise| input impedance phono | 47 K ohm (optional RIAA board) |
|---|---|
| input impedance CD line | 39 K ohm |
| signal-to-noise ratio phono | more than 80dB |
Power and Dimensions| power consumption | 400W |
|---|---|
| dimensions | 430 (W) 110 (H) 390 (D) mm |
| shipping weight | 15 Kg |
To Next Page