Xenus Plus User Guide 16-01344 Rev 06
Copley Controls 5
ABOUT THIS MANUAL
Title, Number, Revision
The Xenus Plus User Guide
Initial Release. Originated from 16-01018 Rev 07
Updated PE symbols and clarified mandatory use of
line filters.
OVC II Mains Requirement and full address for Mfr
& EU Rep. Add model 800-1818
Correct input voltage rating (from 5V to 12V) for
single ended/differential non-isolated digital inputs
Allow use of isolation transformer to eliminate need
for SPD and allow drive operation up to 4000m
Update to reflect EN 61800-5-2:2007
Update to reflect latest revisions of IEC 61800-5-
1:2016 and IEC 61800-5-2:2016
Update to change XEL, XPL, XML STO to MTO to
differentiate from certified STO on XE2, XP2, XM2.
No change to certification of XE2, XP2, XM2.
EC Declaration of Conformity
The products covered by this user guide comply with the applicable EC Directives including
2014/30/EU (EMC Directive) and 2014/35/EU (Low Voltage Directive). Complete EC Declarations
of Conformity are available on the internet at www.copleycontrols.com.
Name and Address of the Manufacturer: Name and Address of the authorized representative:
Analogic Corporation d/b/a Copley Controls BK Medical ApS
20 Dan Road Mileparken 34, DK-2730
Canton, MA 02021 Herlev
USA Denmark
Overview and Scope
This manual describes the operation and installation of the XEL, XE2, XPL, XP2, XML, XM2, 800-
1818, 800-1819 and 800-1887 drives manufactured by Copley Controls. All Xenus Plus products
have serial numbers that incorporate the week and year of production into the first 4 digits (WWYY)
of the serial number.
To Next Page
Loading...
