Operation
Before Use
This refrigerating appliance is not intended to be used as a built-in appliance.
Remove all of the packaging, including the foam backing at the bottom of the unit and the
tape that fixes the shelves and door bins inside.
Place the refrigerator to a proper position, and adjust the feet to level. It is recommended to
wipe out your unit with a warm soapy cloth and dry it thoroughly before use.
Place the refrigerator and adjust to level, clean it, let the refrigerator stand for above 4-6
hours, and then power the unit on. This helps make sure that the oil from the compressor has
settled properly, and will help your unit run normally.
- 12 -
Starting
Connect the power cord, and turn on the power switch.
Upon startup for the first time, the screen will display respective set temperature values (the
temperature of the fridge section is set to 5°C, the temperature of the freezer is set to-18°C).
The default mode is energy saving upon startup: The screen displays for 20s and then goes
off. This mode to save energy and prolong the service life of LED lights.
To Next Page
Loading...
