CORBERO CLAV22714VPINV

Questions and Answers

T
Theresa JohnsonAug 15, 2025
How to reduce foam in CORBERO CLAV22714VPINV detergent drawer?
- P
  Phillip Spence IVAug 15, 2025
  If excessive foam is forming in the detergent drawer of your CORBERO Washer, it could be due to using too much detergent or using the wrong type. To stop the foam, press the Start/Pause button, then dilute one tablespoon of softener into 1/2 liter of water and pour it into the detergent drawer. Press the Start/Pause button again after 5-10 minutes. Make sure you only use detergents specifically produced for automatic washing machines.
K
Katherine HowardAug 18, 2025
How to fix a CORBERO CLAV22714VPINV Washer that won't start?
- H
  hendricksjosephAug 18, 2025
  If your CORBERO Washer doesn't start, several factors could be at play. Ensure the machine is properly plugged in and that the fuses are in good condition. Verify that there is mains power supply. Also, make sure you've pressed the Start/Pause button and that the program dial is set to the desired position, not 'stop'. Finally, confirm that the machine door is completely closed.
J
Jill PattersonAug 22, 2025
What to do if my CORBERO CLAV22714VPINV is not intaking water?
- D
  donald85Aug 22, 2025
  If your CORBERO Washer isn't taking in water, start by checking if the water tap is turned on. Next, inspect the water inlet hose for any twists or clogs. Also, examine the water inlet hose filters and the inlet filters themselves for blockages, cleaning them if necessary. Ensure the machine door is fully closed.
T
Tracy LandryAug 25, 2025
Why is my CORBERO CLAV22714VPINV Washer vibrating so much?
- W
  wanda80Aug 25, 2025
  If your CORBERO Washer is vibrating, make sure the feet have been properly adjusted to stabilize the machine. Check that the transit bolts, used for transportation, have been removed. Avoid overloading the machine with laundry and ensure the laundry is spread evenly inside the drum. Also, avoid placing your washing machine on a hard surface.
T
Tyler RussellAug 28, 2025
What to do if my CORBERO Washer won't discharge water?
- C
  Cynthia OconnorAug 28, 2025
  If your CORBERO Washer isn't discharging water, first check the drain hose for any clogs or twists, cleaning or untwisting as needed. Then, inspect the pump filter for clogs and clean it. Also, ensure that your laundry isn't too tightly packed in the drum; spread it evenly.
A
Allison OdomAug 31, 2025
Why is my CORBERO CLAV22714VPINV not cleaning properly?
- A
  anewmanAug 31, 2025
  If you're getting unsatisfactory washing results from your CORBERO Washer, consider whether the selected program is appropriate for the level of dirtiness of your laundry. Ensure you are using a sufficient amount of detergent as instructed on the packaging. Also, check that you have not exceeded the maximum laundry capacity for the selected program.
J
Jennifer WaltersSep 2, 2025
Why is the spin cycle delayed on my CORBERO Washer?
- T
  Thomas GreeneSep 2, 2025
  If the spin cycle in your CORBERO Washer isn't happening or is delayed, it might not be a fault. The Unbalanced load control system may have been activated. This system tries to spread your laundry evenly. Once the laundry is spread, the spinning cycle will begin. For the next wash, try to load the drum more evenly.
C
Christopher BrownSep 6, 2025
Why does my CORBERO CLAV22714VPINV discharge water immediately?
- S
  samantha17Sep 6, 2025
  If water discharges from your CORBERO Washer as soon as it's loaded, it's likely that the end of the water drain hose is too low. Check that the drain hose is positioned at a suitable height.
B
Bradley JonesSep 8, 2025
What causes detergent residue on CORBERO CLAV22714VPINV Washer laundry?
- P
  pruittkyleSep 8, 2025
  If your laundry has detergent residue after washing in your CORBERO Washer, it may be due to non-dissolving particles in some detergents appearing as white spots. Try performing an extra rinse cycle, or clean your laundry with a brush after it dries.
J
joseph93Sep 12, 2025
Why are there grey spots on my CORBERO CLAV22714VPINV laundry?
- J
  Jennifer WilsonSep 12, 2025
  If grey spots appear on your laundry after washing in your CORBERO Washer, it's likely due to untreated oil, cream, or ointment present on the items. In the next wash, use the amount of detergent as instructed on the packaging.