10
SECTION 03
USE
SETTINGS
The hair dyer temperature can be adjusted using the switch located on the handle of
the hair dryer.
Heat Setting
C Off
1 Low Heat
2 High Heat
1. Use heat setting 2 for fast drying or pre-drying
2. Use heat setting 1 for gentle drying and styling
3. After drying hair, the cool button can be used to set style with a continuous flow
of cool air
IMPORTANT
The hair dryer is fitted with an automatic overheating protection device. In the event of
the unit overheating the hair dryer will switch off. Switch the unit off at the base or
remove the mains supply and allow the unit to cool. After cooling down for a few
minutes, the dryer can be used again. Before reusing, check the intake grille for possible
blockage by fluff, hair, etc.
DRYING
1. Switch the power on
2. Select the desired setting using the heat selection switch
3. Use the trigger to operate the hair dryer.
4. Dry your hair by making brushing movements while holding the dryer at a short
distance from your hair.
Note: The shaver socket incorporates a safety isolating transformer fitted with overload
protection. This inhibits the operation of appliances with a load higher than 12W.
CARE
This appliance should be cleaned with a dry cloth. Never rinse the appliance with
water.
Check the air intake grill regularly, keeping it clear of dust, fluff, hair etc.
SPECIFICATION
Supply voltage - 220-240V 50/60Hz
Rated power - 1600W
Shaver socket - 0.05A / 230V & 0.1A / 115V
To Next Page
Loading...