07
SECTION 02
INTRODUCTION
Thank you for choosing this hair dryer. This product is designed to meet the most stringent
quality, performance, and safety requirements. This guide aims to improve your
understanding of your new hair dryer by providing simple and
informative instructions.
UNPACKING
Carefully unpack the product using the following procedure:
• Carefully lift the parts/product out of the box
• Carefully remove the protective wrapping from the parts
IDENTIFICATION
1600W WALL MOUNTED HAIR DRYER
TOOLS REQUIRED
• Crosshead screw driver
• Electric drill
• 6mm masonry bit
• Pencil
• Spirit level
230V
Shaver socket
Power On/Off
Power
indication LED
Heat selection switch
Trigger
115V
Shaver socket
Mains cord
FIXINGS SUPPLIED
4x Wall plug
4x Screw
PARTS SUPPLIED
1x Hair dryer unit
To Next Page
Loading...