• When wall mounting the product, always check that
there are no water, gas or electrical cables/pipes
within or behind the wall.
• Ensure the mains supply is switched off before
commencing any electrical installation.
• The electrical installation should be carried out in
accordance with current wiring regulations. If in doubt
on any part, please seek advice from a qualified
electrician.
• Ensure your mains supply rating corresponds with that
stated on the rating label fixed to the hair dryer.
• The hair dryer is double insulated and does not require
an Earth (ground) connection.
• The hair dryer must be fixed so that the base unit and
the hand held part, when fully extended, is out of
reach of a person taking a bath or shower.
• Connection of the unit to the electrical supply by fixed
wiring should be made with cable suitable for a 13A
loading.
• When the unit is to be permanently connected to the
fixed wiring, a suitable means for all-pole
disconnection (contact separation of at least 3mm)
should be incorporated (e.g. a switched fuse spur
fitted with a 13A rated fuse)
SAVE THESE INSTRUCTIONS
06
SECTION 01
To Next Page
Loading...