EasyManuals Logo

Core GT User Manual

Core GT
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
User Manual v1.2
5
Flip the kite over, position it on its leading edge and weigh down
with lots of sand. A pre-filled linen sandbag is ideal for none sandy
beaches.
Now you can unwind the lines from the bar and attach them to the
kite as shown in the graphic on page 3.
Now fully inflate the kite up to 6-7PSI. Check that all struts are infla-
ted properly. The maximum inflation pressure for the kite is 7PSI. If
the kite is under inflated it has poor performance and the relaunch
can be difficult. Over inflated kites can burst, especially when they
sit in the sun for any length of time.
Inflate until the kite is almost full and then turn around until your
back is facing towards the wind.
Push the pump nozzle into the inlet (smaller) valve and start to
inflate the kite.
Step 5
Step 6
Step 7
Step 8
Rigging the kite

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Core GT and is the answer not in the manual?

Core GT Specifications

General IconGeneral
BrandCore
ModelGT
CategorySports & Outdoors
LanguageEnglish

Related product manuals