Supersedes 3500-2
Nov, ’03 Feb, ‘05
Cornell Pump Company
DISMANTLING AND ASSEMBLING F18 AND EM18 CORNELL PUMP FRAMES – PAGE
3200-821
CAUTION: Never hammer the shaft or parts attached to the shaft or you will ruin both the shaft and the
bearings.
DISMANTLING AND ASSEMBLING F18DB, EM18DB, AND F18DBK – PAGE 3200-826
CAUTION: Never hammer the shaft or parts attached to the shaft or you will ruin both the shaft and the
bearings.
DISMANTLE AND REASSEMBLE A CORNELL PUMP WITH THREADED SHAFT – PAGE
3200-417
CAUTION: If the sleeve has an “O” ring it should not be heated.
DISMANTLING AND ASSEMBLING EM5/F5 AND EM5K/F5K CORNELL FRAME PUMPS –
PAGE 3200-459
CAUTION: Never hammer the shaft or parts attached to the shaft or you will ruin both the shaft and the
bearings.
DISMANTLING AND ASSEMBLING F16 AND F16K CORNELL FRAME PUMPS – PAGE
3200-810
CAUTION: Never hammer the shaft or parts attached to the shaft or you will ruin both the shaft and the
bearings.
MOUNTING PUMPS TO ENGINES – PAGE 3200-12
CAUTION: All engine driven pumps must be supported and alignment must be assured before bolting frame to
engine flywheel housing.
OPERATION OF COMPRESSORS LOCATED IN CLOSE PROXIMITY TO PUMP
WARNING: Do not allow compressed air to pressurize the pump or vent-off compressed air through the pump
as this may damage pump or cause serious personal injury.
To Next Page
Loading...