What to do if CORNING Laboratory Equipment shaker stalls with message Er1?
If your CORNING Laboratory Equipment shaker stalls and displays the message Er1, power the unit down and then restart it.
What to do if the POWER key does not light on CORNING Laboratory Equipment?
If the POWER key on your CORNING Laboratory Equipment does not light, check the power source and fuses.
Provides technical data including operation range, power supply, motor power, RPM regulation, shaker orbit, timer, load, dimensions, and weight.
Step-by-step guide to powering on, setting time/RPM, and starting/stopping the shaker using the control panel.
Details on how to view and change set RPM or TIME values while the shaker is running.
Covers critical safety advice, including grounding, water avoidance, and avoiding explosive or high-vibration environments.
Provides technical data including operation range, power supply, motor power, RPM regulation, shaker orbit, timer, load, dimensions, and weight.
Step-by-step guide to powering on, setting time/RPM, and starting/stopping the shaker using the control panel.
Details on how to view and change set RPM or TIME values while the shaker is running.
Covers critical safety advice, including grounding, water avoidance, and avoiding explosive or high-vibration environments.
General| Model Series | LSE |
|---|---|
| Manufacturer | Corning |
| Power Supply | 100-240V AC, 50/60Hz |
| Control | Microprocessor |
| Safety Features | Over-temperature protection |
| Power Requirements | 100-240V AC, 50/60Hz |
To Next Page
