CORNING LSE Series - Page 6

CORNING

LSEDIGITAL MICROPLATE AND ORBITAL SHAKERS USER’S MANUAL
6
POWER
t (min)
nx10 (RPM)
RUN TIME RPM
Push
Time/RPM
 Time signal light is on. By rotating the encoder right (+) or left (-) the set time can be selected
from 30 sec to 99 min 50 sec :
99.5  99 min 50 sec
9.59  9 min 59 sec
0.30  30 sec
POWER
RPMTIMERUN
nx10 (RPM) t (min)
Push
Time/RPM
 If you want to set the timer to hold – turn the knob left or right until HLd is displayed. You can
reach the HLd function by setting to under 0.30 or above 99.5
 Push down on the encoder knob to switch modes between time set mode and RPM set mode.
POWER
t (min)
nx10 (RPM)
RUN TIME RPM
Push
Time/RPM
 RPM signal light is on. By rotating the encoder right (+) or left (-) the desired RPM can be
selected :
34  340 Rpm
120  1200 Rpm
 Press START/STOP button to start operation