© Corroventa Avfuktning AB
User instructions CTR 300TT2
Area of use
The CTR 300TT2 crawl space dehumidifier is intended for permanent installation in crawl spaces with
the primary purpose of preventing the build up of mould and rot in the building construction by
dehumidifying. By using the adsorption principle for drying the air in the space, the dehumidifier is
effective at low temperatures and it also works just below freezing. CTR 300TT2 also has a patented
solution for increasing the negative pressure in the crawl space without needing to reduce the
efficiency of the dehumidifier. With the possibility of increased wet air volumes, the CTR 300TT2 is
the right choice for buildings with radon problems or problems with bad air from the crawl space. A
crawl space dehumidifier like this shall be dimensioned for 1.5 to 2 air exchanges per hour, which
makes CTR 300TT2 suitable for crawl spaces with a volume of up to 180 -200m
3
.
For the user's comfort, for control and monitoring of the dehumidifier's operation and function, the
CTR 300TT2 is developed for use with Homevision® Pro or Homevision® Lite. These contain control
units, which are connected by cable to the dehumidifier as well as to a wireless control panel
mounted in the living area. The control unit is equipped with a thermometer and hygrometer and
independently controls operation of the dehumidifier. The system can be monitored and operational
settings adjusted via the control panel. The control panel also shows any operational alarms and
service reminders, such as filter replacement.
Properties:
• Homevision® Lite/Pro connection
• Capacity to eliminate odour and radon problems
Manufacture directive
Crawlspace dehumidifier CTR 300TT2 is CE marked.
Disclaimer
• Incorrect installation and/or incorrect handling can cause property damage as well as injury.
• The manufacturer assumes no liability for damage arising as a result of failing to follow these
instructions, not using the machine as intended. Such damage is not covered by the
warranty.
• The warranty applies to damage to the machine caused by material or manufacturing defects
and does not cover consequential failure.
• The warranty does not apply to consumables or to normal wear.
• It is the responsibility of the purchaser to inspect the goods upon delivery and to ensure its
function according to the instructions in the manual during use.
• Changes or modifications to the machine must not be performed without written permission
from Corroventa Avfuktning AB.
• The product, technical data and/or installation and operating instructions are subject to
change without notice.
To Next Page
Loading...
