Hardware Installation Guide
Let’s get started!
Installing Corsair Link Commander
1. Mount the Commander inside your case to any available 5.25” HDD bay
2. (A) Locate any available USB header on your motherboard (B) Connect the USB cable
from the commander to your motherboard USB header.
(A) (B)
Installing the Cooling Node to the Commander
Note: For this installation you will need the following:
o Corsair Link Cooling Node
o Corsair Link Digital Cable
o Temperature Sensor cable
1. Mount the Cooling node anywhere on your case with the provided double-sided sticky
tape.
2. (A) Connect the Corsair Link digital cable to any one of the available 8 ports on the
commander unit. (B) Connect the other end of the Corsair Link Digital cable to your
cooling node digital port.
(A) (B)
To Next Page
Loading...
