3. You can use the temperature sensor to monitor temperatures anywhere on your case.
(A) Locate the temperature sensor ports on the cooling node. (B) Plug in the
temperature sensor cable into any one of the 4 ports.
(A) (B)
4. You can connect and control up to 5 fans per cooling node.
(A) Locate the fan ports on the cooling node. (B) Plug in your fans 3-pin or 4-pin header
into any one of the 5 ports.
(A) (B)
Installing the Lighting Node to the Commander
Note: For this installation you will need the following:
o Corsair Link Lighting Node
o Corsair Link Digital Cable
o RGB LED Extension cables
o RGB LED Strips
1. Mount the lighting node anywhere on your case with the provided double-sided sticky
tape.
To Next Page
Loading...
Need help?
General
