Cosco Scenera - Install Rear Facing with Vehicle Belts

F-4 Install Rear Facing with
Vehicle Belts
NOTE: Review section D-4 to determine what kind of vehicle
belts you have. Review your vehicle owner’s manual for seat
belt use.
Do not use the UAS along with the
vehicle lap or lap/shoulder belt.
Secure UAS belts as shown when
using the vehicle belts.
Check the vehicle belt before each use. Use only if
the belt can be tightened properly and securely.
Secure the tether hook to the tether
attachment when used rear facing.
Do not use the upright position when
rear facing. Do not recline the child restraint
beyond the level-to-ground line.
Failure to follow these warnings can result in
serious injury or death.
41
Place Child Restraint in Vehicle
Rear Facing in the Back Seat
Child restraint MUST be in the
reclined position when rear-
facing. To fold in recline stand, see
section C-5.
Make sure level-to-ground line on
the side of the child restraint is level
with ground. Adjust child restraint if
needed.
NOTE: Only if needed, you may use
a rolled towel(s) or foam noodle(s)
under the front of the child restraint where the vehicle’s seat back
meets the vehicle’s bench seat to get the correct recline angle.
1.
4360-0681
L
i
ne
to
be
L
e
v
el
To
G
r
ound
R
e
ar
-
F
ac
i
ng
O
n
l
y
436
0-
0681
43
6
0
-06
81
43
6
0
-06
81
Thread Vehicle Belt
Thread the vehicle lap or lap/
shoulder belt through the rear-
facing belt path.
With an ALR belt, pull the
belt all the way out before
threading.
With a switchable retractor, pull the shoulder belt all the
way out to switch the retractor into the ALR mode before
tightening.
continued on next page.
42
Pull Vehicle Latch Plate
Across to Opposite Side
Reach under pad and pull the
vehicle belt across the shell and
out the rear-facing belt path on
opposite side.
Buckle vehicle belt. Vehicle belt
MUST be under pad and in front of buckle strap as shown.
Do not place vehicle belt over child’s legs.
NOTE: You must use the 1st or 2nd buckle strap slots
when rear facing.
2
1
F. Install Rear Facing
3.
4360
-068
1
L
i
ne
to
be
L
ev
e
l
To
G
r
ound
R
e
ar
-
Facing
O
n
l
y
2.
Tighten Vehicle Belt
Place hand in child restraint and
firmly push down and towards the
vehicle seat back while pulling up
on the shoulder belt or lap belt to
tighten.
With a switchable retractor, feed
the shoulder belt back into the
retractor while tightening.
It may be easier to tighten the belt
through the belt path opening as
shown.
4.
4358-5974A CAN Scenera ENG.indd 43-444358-5974A CAN Scenera ENG.indd 43-44 10/23/14 8:57 AM10/23/14 8:57 AM