Cosco Scenera - Using the Locking Clip; Locate and Attach Locking Clip; Position and Rebuckle Vehicle Belt

53
54
H. Using the Locking Clip
You will rarely need to use a locking clip except in some
older vehicles.
A locking clip is used to prevent the vehicle belt from
loosening before a sudden stop or crash. The locking
clip can only be used on a lap and shoulder belt
combination.
A locking clip will not fix all types of vehicle seat belt
problems.
Review section D-4 and your vehicle owner’s manual
for vehicle seat belt use with child restraints to see if a
locking clip is needed.
If you need a locking clip, purchase one from your retailer or
call us at 1-800-544-1108 to order one.
Locking clips from any child restraint manufacturer are okay
to use.
H. Using the Locking Clip
Locate Locking Clip
Location
Grasp the vehicle lap/shoulder
belts together tightly as close
to the vehicle latch plate as
possible. While holding the
belts tightly, unbuckle.
NOTE: If the latch plate ends up just at the belt path
opening so you cannot grasp the vehicle belt at the latch
plate, grasp the vehicle belts on the opposite side of the
child restraint, as close to the latch plate as possible.
1.
Rebuckle Vehicle Belt
4.
2.5 cm
(1 in.)
Position Locking Clip
Position locking clip about 2.5
cm (1 in.) from vehicle belt’s
buckle plate.
3.
Attach Locking Clip
Thread both portions of the
vehicle belt onto the locking clip,
as close to the latch plate as
possible.
2.
For Rear Facing installation, follow Section F-4
Warnings and Steps 1-4 before starting locking clip
installation.
For Forward Facing installation, follow Section G-5
Warnings and Steps 1-3 before starting locking clip
installation.
continued on next page.
Locking Clip
4358-5974A CAN Scenera ENG.indd 55-564358-5974A CAN Scenera ENG.indd 55-56 10/23/14 8:57 AM10/23/14 8:57 AM