2
8. MAINTENANCE
The ordinary maintenance criteria we suggest, are based on the company experience and on the advices
and suggestions from our customers.
Such criteria are not exhaustive can be further integrated also with the collaboration of the customers that
we thanks in advance.
A good ordinary maintenance keeps the operating costs of the machine low and provide an
integral exploitation of its potentialities.
In damage case, the operator must stop the machine immediately, assess the entity of the
problem and
proceed with eventual actions on the machine.
If pressure water or compressed air is used for the cleaning of the machine, it is necessary to
protect oneself with proper glasses or protection masks and to remove eventual persons or
animals near the machine. Do not use inflammable fluids.
Every 8 hours of effective job, control the tightness of all nuts and bolts.
In case of anomalous vibrations, verify the status of wear of the vanes of the spreading disc, the
corrected tightness of all the nuts and bolts and the lubrication of the gear box.
The excessive vibration of the machine, besides the specific annoyance, is dangerous and
damaging for the entire structure subjecting the mechanical parts to more and more stress cycles
compared to the advice pictures.
As regards particular actions that the user does not know or regarding broken parts replacing
which are not shown in this manual, it is necessary to consult specialised personnel, making use
of the Assistance service by the manufacturer or its distributors.
ATTENTION!
Whichever work of maintenance, regulation and cleaning must
be carried out with the machine on the ground (in stable
conditions), engine turned off, handbrake set, key of ignition off
and removed from the ignition board.
ATTENTION!
For the maintenance operations, always use the fit Individual
Protection Devices (accident-prevention footwear and gloves)
and to prepare all the accident- prevention steps for the type
of operation in course.
To Next Page
Loading...
Need help?
General
