Touch the switch button , to enter the working state, default high
gear for humidification.
Touch the button again to enter the standby state.
Touch the timing button, the timing transformation order is:
1h-2h-3h-4h-5h-6h-7h-8h-0h cycle.
The timing is displayed as the countdown timing; it will stop working
and enter the standby state when the timing arrives.
Press the sleep key , to enter the low gear for humidification;
touch the sleep key again to exit sleep mode.
When the water tank is short of water, the buzzer sends an alarm,
the machine stops working, goes into standby state, and the digital
tube flashes for a period of time and then goes out.
1. Read the operation instructions of this manual in detail when you
use the product, and keep it properly for future reference.
2. The power supply of this product is AC100-240V, 50/60 Hz.
3. Please use it on a smooth desktop or ground to prevent the
product from tilting and falling, resulting in the water overflow or
damage to humidifier.
4. Please install the water tank on the seat before turning it on. It is
strictly forbidden to touch the atomization sheet with your hands for
the high temperature produced by the atomization sheet will burn
your hand.
5. Do not allow children to use this product separately
6. Do not turn turn on electricity when water injection and cleaning,
do not turn on when there is no water in the seat.
7. Do not use it if there is a lack of product components, power cord
breakage and other phenomena.
8. Please cut off the power when it is thunderstorm or not in use for
a long time.
9. This product is suitable for clean water with temperature below 40
℃/104℉. When room temperature is below 0℃/32℉, please pour
out the water in water tank and sink.
10. In the event of damage to the power cord, it must be replaced by
professional staff in order to avoid danger.
Touch the gear adjustment button , to reach high and low gear
cycle adjustment.
Touch the humidity setting key , for the humidity cycle setting
from CO →40% →50% →60% →70% →CO.
It will stop working when the ambient humidity reaches the set
humidity value, and start working when the humidity is below the set
value.
04 05
1. Open the top cover 2. Add clean water
3. Cover the top cover 4. Plug in
II. Using Method
III. Operational Guidelines
V. Safety tips
ES10231Operations for
I. Power switch
II . Gear adjustment
III . Humidity control
IV . Timing function
V . Sleep function
VI. Water shortage protection
To Next Page
Loading...