06 07
VI. Elimination of common problems
VII . Main Technical Parameters
Water shortage in water tank.
Abnormal
phenomenon
Reason
Add water to the tank.
Processing
method
Red light on indicator light
The top cover is not covered
Abnormal
phenomenon
Reason
Cover the top cover.
Processing
method
Long time fog leakage from the top cover
There are foreign matters at the outlet.
Product model
Humidifier
Rated voltage: AC100-240V
Control mode:
touch / mechanical adjustment
Tank capacity: 4L
Rated power
22W
Rated frequency: 50/60 Hz
Rated humidification: 280 m/h
Product size:
172 x 172 x 315 mm/7” x 7” x 12”
Abnormal
phenomenon
Reason
Clean the outlet of water tank.
Processing
method
Water overflow
1. The power plug is loose or the power switch
is not turned on.
2. Dirty water or atomization board.
3. The environmental humidity reaches the set
humidity.
Abnormal
phenomenon
Reason
1. Plug the power plug again and turn it on.
2. Replace clean water and clean atomization
board.
3. Adjust the set humidity.
Processing
method
Do not work or small fog
1. The water tank of the new machine has not
been cleaned.
2. The water in the tank has not been
replaced for a long time.
Abnormal
phenomenon
Reason
1. Clean the water tank, remove the inlet and
place it in the shade for 12 hours.
2. Clean water tank and replace clean water.
Processing
method
Smelly fog
Note: If the problem still exists, or if there are other problems, please
ask qualified technician for help and it is not allowed for non
-professionals to disassemble or assemble this machine on its own.
To Next Page
Loading...