ENGLISH
2. Turn the cut off switch (7) to position “1”. See picture 7
3. Turn the choke (9) to the “COLD START” position. See
picture 8.
4. Pump the primer pump (14) 8 times (the primer pump is
located on the bottom of the carburettor). See
picture 9.
5. Holdtherearhandlermlyandatthesametimeholdinthe
safety catch and throttle (6) See
picture 10.
6. Pull the starter handle until you feel some resistance (approx.
100 mm) See
picture 11, pull the starter handle quickly yet
smoothly.
7. Assoonastheenginehasstartedorred,thechokeshould
be set to the “WARM START” position, if it cuts out attempt to
restart it with the choke in the “WARM START” position.
8. Once started, let the engine run without any load for 10 seconds.
7.2 Starting a warm engine
1. Place the grass trimmer on a level surface.
2. Turn the ignition switch (7) to position “1”. See
picture 7.
3. Holdtherearhandlermlyandatthesametimeholdthe
safety catch (8) and the throttle (6) in completely. See
picture 10.
4. Pull the starter handle until you feel some resistance (approx.
100 mm) See
picture 11, pull the starter handle quickly and
smoothly until the engine starts or up to 6 times in quick
succession.
5. If the engine doesn’t start: Repeat all the steps in “Starting the
engine from cold”.
7.3 Switching the engine off
Release the throttle and let the engine idle, turn the ignition switch
(7) to “STOP”. See picture 7.
Helpful suggestions
Warning! Remove all objects such as cans, bottles and sto-
nes from the ground before starting to use the grass trimmer,
otherwise they can be thrown about by the trimmer line and
cause injury or damage the trimmer.
Switch off the grass trimmer at once and check it for damage if you
notice that something is ejected or if the grass trimmer starts vibra
-
ting. Do not operate the grass trimmer if it has been damaged.
Note! Allow the engine to reach full speed before starting to cut the grass, never try to cut
grass at low speed.
Warning! Never raise the trimmer head above knee-height when it is spinning.
Warning! Never use metal or plastic coated metal trimmer line, this could cause serious
accidents.
Picture 7
Picture 8
Picture 9
Picture 10
Picture 11