EasyManua.ls Logo

Cotes CR300 - 13. SERVICE;REPAIR.; 13.1 SAFETY INSTRUCTION.; 13.2 REPLACING ELECTRIC COMPONENTS.; 13.3 REPLACING OF GEARMOTOR, REG.FAN, THERMOSTATES ST3.

Default Icon
23 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page20
Beforeopeningthedehumidifier,makesurethatthe
electricpowerisswitchedoffonthemainswitch.
IntheE-boxbehindthecoveronthefrontofthe
cabinetyouwillfindthefollowingcomponents:
-internalterminals
-powerlinefilter
-hourcounterP1
-relaysKA1,KA2
-thermostatsST1,ST2*)
-neonsHL1,HL2
-selectorswitchSA1
*)Whenthecoverisremoved,thesecomponentsare
accessibleforreplacing.
Toremovethetermostats,thesensorplacedinthe
heaterboxmustberemovedatfirst.Thesensorsare
accessiblewhenthecabinettopcoverisremoved.
Whenthetopplateisremovedthesecomponentsare
accessibleforreplacement
Whenthetopplateisremoved,theprocessairfanis
visibleonthecabinetbackplate.
Thefancanbeunscrewedfromtheoutsidewhenthe
filterisremoved.
Reg.-airfan,andtheplatewithelectriccomponents
areallfixedtotheheatingboxasoneunit,andcan
beremovedasonepiece.Dolikethis:
-removetheinsulationfromtheØ100connectionfrom
theheatingboxtotherotorsection-unscrewthe
rubberconnectionunderneithfromtheonepart.
-unscrewtheheatingboxfromtheundersideofthe
dehumidifier(4pcsUnbrakoM6)
-disconnectallelectricconnectionsontheheaters
-removetheheatingboxunit.
Removethetopplateandthebackcabinetplate.
Forremovingthebackcabinetplate,atfirstunscrew
thetworeg.-connectionsfromtheplate.Theyarefixed
by4pcsM5screwseach.
Forremovingtherotor,thebackdividingplatemustbe
removedatfirst.Thisisfixedby5pcsscrewsM6for
distancebolts,onepcsM8screwinthemiddleforthe
shaft,2pcsM5screwsineachside,and2pcsM6into
thebuttonframe.
Whenthebackdividingplateisremoved,rotor,gaskets,
shaftandtimingbeltcanberemovedifnecessary
13.SERVICE/REPAIR.
13.1SAFETYINSTRUCTION.
13.2REPLACINGELECTRICCOMPONENTS.
13.3REPLACINGOFGEARMOTOR,REG.FAN,THERMOSTATESST3.
13.4REPLACINGOFPROCESSAIRFAN.
13.5REPLACINGOFHEATINGELEMENTS.
13.5REPLACINGOFROTOR,ROTORGASKETS,ROTORSHAFT,TIMINGBELTS.

Related product manuals