Country Hearth 2000 User Manual

Owner’s Operation and Instruction Manual
C
S
S
U
C
O
M
P
A
N
Y
U
N
I
T
E
D
S
T
A
T
E
S
S
T
O
V
E
SAFETY NOTICE:
If this heater is not properly installed, a house
re may result. For your safety, follow the in-
stallation instructions. Never use make-shift
compromises during the installation of this
heater. Contact local building or re ofcials
about permits, restrictions and installation
requirements in your area.
CAUTION!
Please read this entire manual before you
install or use your new room heater. Failure
to follow instructions may result in property
damage, bodily injury, or even death.
Improper Installation Could Void
Your Warranty!
SAFETY TESTED TO UL 1482 and ULC-S627
US ENVIRONMENTAL PROTECTION AGENCY PHASE II CERTIFIED WOODSTOVE
WASHINGTON STATE APPROVED
MOBILE HOME APPROVED (U.S. ONLY)
United States Stove Company
227 Industrial Park Road
P.O. Box 151
South Pittsburg, TN 37380
SAVE THESE INSTRUCTIONS
THIS MANUAL WILL HELP YOU TO OBTAIN EFFICIENT, DEPENDABLE SERVICE FROM THE HEATER, AND ENABLE YOU
TO ORDER REPAIR PARTS CORRECTLY. KEEP IN A SAFE PLACE FOR FUTURE REFERENCE.
851710 rev C
MODELS: 2000(L)(LN), 2500(L)(LN)
2000 Report #: 215-S-29-2
2500 Report #: 215-S-23-2
TESTED &
LISTED BY
PORTLAND,
OREGON, USA
For service questions, contact US Stove at 1-800-750-2723.
For sales inquiries, contact Sylvane at 1-800-934-9194 or visit www.sylvane.com.

Country Hearth 2000 Specifications

General

Brand	Country Hearth
Model	2000
Category	Wood stove
Language	English

Summary

Wood Stove Installation and Safety

Installation Tools and Materials

Lists required tools and materials for stove installation.

Stove Assembly Steps

Details the assembly steps for various stove components.

Installation Procedures and Safety

Covers safety notices, positioning, floor protection, and clearances.

Chimney System Installation

Guidelines for chimney connectors, factory-built, and masonry chimneys.

Stove Operation and Maintenance

Wood Fuel and First Fires

Guidance on wood selection, utilization, and initial fire procedures.

Ignition and Heating Control

Steps for starting a fire and controlling heat output.

Reloading and Creosote Management

Best practices for reloading and preventing creosote buildup.

Ash Disposal and General Maintenance

Procedures for ash disposal, maintenance, glass, and gasket care.

Repair Parts and Ordering

Repair Parts Identification

Diagram and key for identifying stove components.

How to Order Repair Parts

Information and steps needed for ordering replacement parts.