COUNTRY SMOKERS CS150PPG User Manual

52 pages

To Next Page

DISCOVER COUNTRY SMOKERS

WOOD FIRED GOODNESS

TROUVEZ DES RECETTES DE BIENFAISANCE AU BOIS AU

COUNTRYSMOKERS.COM

CS150PPG

MODEL / MODÈLE : CS150PPG

PART / PIÈCE : 10497, 10718

FOR OUTDOOR AND HOUSEHOLD USE ONLY. NOT FOR COMMERCIAL USE.

FUEL AND ACCESSORIES NOT INCLUDED.

RÉSERVÉ À L’USAGE EXTÉRIEUR ET RÉSIDENTIEL UNIQUEMENT. NON DESTINÉ

À UN USAGE COMMERCIAL. COMBUSTIBLE ET ACCESSOIRES NON INCLUS.

ASSEMBLY & OPERATION | ASSEMBLAGE ET FONCTIONNEMENT

   

IMPORTANT, READ CAREFULLY, RETAIN

FOR FUTURE REFERENCE. MANUAL

MUST BE READ BEFORE OPERATING!

  

  

IMPORTANT, PRENEZ CONNAISSANCE

DE CE DOCUMENT ET CONSERVEZ-LE

POUR RÉFÉRENCE ULTÉRIEURE. VOUS

DEVEZ LIRE CE GUIDE AVANT

D’UTILISER LE BARBECUE!

5005166

Questions and Answers:

J
Joseph KramerAug 18, 2025
Why is there no power on my COUNTRY SMOKERS Grill control board?
- R
  Ronald LyonsAug 18, 2025
  If there are no power lights on the control board, several issues could be the cause. First, ensure the Temperature Control Dial is set to a temperature. Check that the unit is properly plugged into a working power source and reset the breaker. Confirm the GFCI is a minimum 10 Amp service. Also, verify all wire connections are secure and dry. The fuse on the control board might be blown, requiring manual replacement. In addition, ensure GFCI is a minimum 10 Amp service. Lastly, the control board itself may be faulty, requiring replacement; contact Customer Service for assistance.
U
usanchezAug 20, 2025
What to do if the fire pot won't light in my COUNTRY SMOKERS CS150PPG Grill?
- C
  christopher75Aug 20, 2025
  If the fire pot in your grill won't light, it could be due to several reasons. First, the auger may not be primed, especially if it's the first use or the hopper was emptied. Follow the Hopper Priming Procedure. The auger motor could also be jammed; inspect the auger feed system to confirm pellets are dropping into the fire pot. If not, contact Customer Service. An igniter failure could also be the reason; check if the igniter is working by feeling for heat above the fire pot and ensure it protrudes about 13mm / 0.5 inches into the fire pot. If it's not working, follow the Manual Start-up Procedure and contact Customer Service. Lastly, insufficient airflow due to ash build-up or obstructions in the fire pot or a blocked fan could be the cause; follow the Care and Maintenance instructions.