What to do if CountyComm GP-7/SSB Receiver alarm goes off but only noise is heard?
If you only hear noise when the alarm goes off, make sure the CountyComm Receiver is placed in a location where it can properly receive broadcasts.
Why does my CountyComm Receiver skip some stations?
If your CountyComm Receiver skips some stations, it might be due to interference or incorrect tuning. Try to manually set and tune the stations.
How to fix North America reception issues using MW on CountyComm GP-7/SSB?
If you are experiencing North America reception issues using MW on your CountyComm Receiver, turn off the device and press the tuning button 10 kHz spaced.
What to do if CountyComm GP-7/SSB Receiver radio is not activated?
If the CountyComm Receiver radio is not activated, deactivate the sleep timer and replace the battery.
How to fix power issue on CountyComm GP-7/SSB?
To fix a power issue on your CountyComm Receiver, reinstall or replace the battery.
Instructions for charging the device's battery.
How to set the device's internal clock time in 24-hour format.
Configuring the FM band reception range based on geographical region.
Adjusting MW/AM band range and tuning increments (e.g., 9kHz or 10kHz).
Instructions to activate or deactivate the Longwave (LW) band.
Basic operation to power the device on and off using the POWER button.
Adjusting the audio output level using the VOLUME knob.
Modes for viewing radio frequencies (VF) and stored memories (VM).
Guidance on utilizing the internal FM/SW telescopic and external MW/LW ferrite antennas.
Methods for finding stations: manual tuning, auto scan, and direct keypad entry.
Using numeric keypad to directly input station frequencies.
Switching between different Shortwave (SW) and Single Sideband (SSB) meter bands.
How to store and manage radio station presets using memory functions.
Recalling saved stations and performing memory scans.
Procedures for removing single or all saved radio stations.
Guide to using ETM+ for automatic station scanning and storage into ETM memory.
How to access and listen to stations stored in ETM+ memory.
Steps to remove individual stations from ETM+ memory.
Automatically organizing and deduplicating stored stations by frequency.
Explanation and activation of Single Sideband reception mode for clearer signals.
How to enable Synchronous Detection to reduce interference and distortion.
Adjusting AM signal bandwidth for improved clarity and interference reduction.
Switching between stereo and mono reception for FM broadcasts.
Setting the FM de-emphasis time constant to 50µs or 75µs.
Customizing information displayed on the device screen.
Options for clock display including enabling the seconds count.
Configuration options for the screen backlight behavior.
How to set the radio to turn off automatically after a specified time.
Programming the alarm activation time and selecting the alarm broadcast station.
Using the alarm snooze feature and activating the keylock function.
Selecting the unit for temperature display: Celsius or Fahrenheit.
Solutions for the device not powering on.
Reasons and fixes for the radio shutting down unexpectedly.
Troubleshooting issues with station scanning and stored audio quality.
Addressing reception problems on the MW band in North and South America.
Resolving issues when attempting to access or use ETM memory.
Diagnosing alarm issues where only noise is heard instead of a broadcast.
General| Brand | CountyComm |
|---|---|
| Model | GP-7/SSB |
| Category | Receiver |
| Language | English |
To Next Page
